Assembled, Sewn, Safety Tested and Approved, Packaged in the US and Federal Safety (FMVSS) #302 #209 Certified!
• 3 Point Seatbelt • Retractable Seat Belt • Modern End Button Release Buckle • For Convertibles or Hardtop Trucks or Cars
Choose either bucket bench seat, color & optional hardware.
Buy this made in U.S.A. aftermarket replacement seat belt for sale price. It is a universal fit truck or car safety harness. It is designed for maximum cross compatibility, but may require some modifications to install. Compare our installation instructions to your vehicle to insure compatibility. Buy this end-button release buckle safety seatbelt.
FMVSS #209 and #302 Federally Safety Certified.
Safety tested and approved, assembled, sewn, packaged in the USA.
Does NOT have electrical wiring, so they cannot be electrically wired to alarms or airbags.
3 point seat belt (both lap and across shoulder) with End-Button-Release Buckle.
Choice of: Bench Seat 20 inch Floppy End20 inch Bench Seat Floppy End, 8" or 11" Rigid Sleeve EndYour Choice of Rigid Sleeve Length for Normal to High or Low Bucket Seats.
For vehicles where the Shoulder Anchor Point is below the bottom of the side window. Click HereFor convertible or hardtop cars where shoulder sash anchor point is or will be located just below bottom of side window level.
Price includes 1 seat belt for 1 person / seat.
Works for both passenger or driver side, front and some back seat applications.
Webbing (belt) extends up to 120" out of retractor box. "Hey Wesco, you know everything! How do I figure out what seat belt length is required?" Simple, gotcha' covered! See Our Seat Belt Install Measuring Instructions
It retracts neatly out of the way when you unbuckle.
Equipped with ELR Retractor What's That? for maximum comfort AND safety.
For front seat installations with a high middle console (17" or more when measured from floor to top of console), one 6 inch extension bracket # 6-AB
is needed for each seat belt installed (front seat). Click Here6 inch extension bracket needed for center consoles that are higher than 17 inches.
to see how it attaches to the seat belt end.
Compare the installation instructions to your car, truck or van to confirm that this seat belt is compatible with your automobile.
The retractor box is H: 4" x W: 4" x D: 3" and you want to make sure that you have sufficient space at the installation point area near or on the floor of your car to accommodate the retractor.
Optional hardware kitOptional Hardware Kit Includes All that is Shown.
includes HW#12 Bolt Kit Mounting Hardware, plus 1 Angle Bracket, 1 Shoulder Bolt & 1 Mounting Plate. Or see our Seat Belt Hardware Page
What is a Hardtop? Click Here
What is a convertible? Click Here
To install a 3 point seat belt, your auto must have a manufacturer's shoulder bolt attachment point or you must create one (retrofit one). How do I create one? Click Here to Find Out!